Buy Fabrics [USA] |
Here are the specifications,please respond with a quote,we are going to need 2 yards of each type for samples.I wait for your prompt response.
DESCRIPTION This commodity standard sets forth the requirements for polyester/cotton blend and 100% cotton broadcloth to be used for boxer shorts.
2.0 SPECIFICATIONS AND STANDARDS Specifications and standards in this document form a part of this specification where noted.
Specifications
California Prison Industry Authority
• General Requirements for Procurement – Fabric
Test Methods
American Society for Testing and Materials (ASTM)
• D3774 Width of Woven Fabric
• D3775 Fabric Count of Woven Fabric
• D3776 Mass per Unit Area (Weight) of Woven Fabric
• D5034 Breaking Strength and Elongation of Textile Fabrics
American Association of Textile Chemists and Colorist (AATCC)
• No. 96-2001 Dimensional Changes in Commercial Laundering of Woven & Knitted Fabrics
3.0 REQUIREMENTS The fabric shall meet or exceed the following requirements for materials, construction, durability, color, and packaging.
3.1 Material The fabric content shall be the type typically used in the industry for boxer shorts and which meets the other provisions of this specification. The warp and fill yarn shall be intimate blend. There shall be two types of broadcloth.
Type 1 – The blended fiber content shall be a minimum of 50% cotton and no more than 55% cotton. The remaining fiber shall be polyester.
Type 2 – The fabric content shall be 100% cotton.
June 2008
California Prison Industry Authority
Commodity Standard
Fabric, Apparel, Broadcloth
3.2 Construction
Color: Bleached white.
Weave: Plain
Width: 60 inches minimum cutting width. (ASTM D3774)
Thread Count: Thread counts specified below are the minimums for each type.
(ASTM D3775) Type 1 Warp 102 threads per inch
Fill 54 threads per inch
Type 2 Warp 72 threads per inch
Fill 64 threads per inch
Weight: 3.2 ounces minimum per square yard. (ASTM D3776)
Breaking Strength: Warp - 70 pounds minimum (ASTM D5034)
Fill - 30 pounds minimum
Shrinkage: 3% maximum in warp and fill directions after 3 industrial launderings (AATCC No. 96, Test 3A).
4.0 WORKMANSHIP AND GRADE
The finished fabric shall be clean and evenly woven. All fabric shall be consistent in color. Grade shall be first quality only. Shorts of not less than 50 yards (without a seam) will be acceptable up to a maximum 3% of the total order.
5.0 PUT-UP
Fabric shall be rolled on tubes in 150 yards minimum to 250 yards maximum.
Tubes shall have a minimum inside diameter of 1.25”. Each roll shall be protected by heavy kraft paper, plastic or similar material. The individually wrapped rolls may then be put in cartons. Cartons or individual rolls will then be palletized and strapped. Each shipment must contain a packing list, including purchase order number |
|
 |
